6 Axis MACH3 Engraving Machine Interface Board PWM Spindle CNC Stepper Motor Driver Control Board

6 Axis CNC MACH3 Engraving Machine Interface Board  PWM Spindle

P10 -- IN1 E-stop

P11 -- IN2 Alternate

P12 -- IN3 Alternate

P13 -- IN4 3Axis limited 

P15 -- IN5 Alternate

P2 -- X Axis pulse

P3 -- X Axis direction

P4 -- Y Axis Pulse

P5 -- Y Axis direction

P6 -- Z Axis pulse

P7 -- Z Axis direction

P8 -- A Axis pulse

P9 -- A Axis direction

P14 -- relay port

P16 -- relay port

P17 -- relay port

   One is 9-32V input (DC, with power light indicator)

   Another one is 5V, it is taken from the USB port, meaning that this paragraph must be connected to an interface board USB cable before they can work. Because to do isolation protection, so these two places with the USB supply voltage must be relatively independent of the supply voltage is open to the job

The CNC control board is designed for MACH3 software used in computer with line print terminal.The CNC control board is extensively used in the CNC machining,such as: CNC engraving machine,CNC lathes,

CNC Plasma cutting machine,CNC laser engraving machine,CNC milling machine,CNC Machining center and so on.It can be the most cost-effective method using the CNC control board with mach3 software in the computer.

1. High integration high reliability

2.Absolute voltage isolation. The CNC control board is powered by computer USB port used as digital power that designed as common cathode and common encode 

which is connected to motor drivers common port,and another power is DC 12V to DC 24V which is used as analog power.Its much more safe and stable by isolating the digital power from analog power.

3.Five signal ports are isolated by optocouplers which can be used as limitting position finding origin points,starting and stopping. There is no interruption with isolation of optocouplers.

4.Twelve output ports can control six motors simultaneously,and they are also can be used for some ports as you like.Some ports are communally designed for two functions,choice should be made if you 

want to use them.

5.Three relays are put on the board that can be programmed in the mach3 software,and there are three leads used for pilot lamp. The relays can be used to control external equipment such as solenoid valve, cooling pump and so on.

6.Programmed analog voltage from zero to ten volt can be set.The analog voltage can control the speed of spindle motor.

7. The CNC control board can control step motor diver with common cathode or common anode.It also can control servo motor with digital signal.

8.The analog power can be from 9 volt to 30 volt.